Home

Product Banner
Wireless LAN Router

Compatible

Router

It is focusing on providing a simple Wireless Internet Access solution for the SOHO users.

Feature

  • LAN/WAN Interface Modularit
  • Robust IP Routing Service
  • Multiple IP Access Service
  • Advanced IP Quality of Service
  • System Reliability
  • User Friendly
 Application

General Specifications

Standards:           IEEE802.11b Compliant
Data Rate:           11Mbps / 5.5 Mbps / 2Mbps / 1 Mbps
                           auto fallback
Security:              Wired Equivalent Privacy (WEP)
                           Data Encryption (TBD)
LED Indicators
LED Quantity:
  • 1 Red for Power on/off
  • 2 Green for Wireless functions
  • 3 Yellow for WAN functions
  • 3 Orange for LAN functions

 RF Specification General

Emission Type                  Direct Sequence Spread Spectrum
                                        (DSSS)
RF Frequency                   2400MHz ~ 2483.5MHz   Europe
Operating Channel            13 Channels (Europe)
Radio Chipset:                  Intersil PRISM II
Baseband Processor         HFA3861B or HFA3863
MAC Controller               MAC Atmel AT76C510
Radiation Power               13 ~ 20 dBm at maximum radiation
                                         direction 
Transmitter
RF Output Power             12dBm
Frequency Stability           Within ± 25 ppm
Data modulation type        BPSK (1/5.5Mbps) / QPSK
(2/11 Mpbs)

Reciever

Sensitivity                          -80 dBm (Typically @25°C± 5°C)
(Less than 8% of FER packet sizes is 1024 bytes)

Antenna Type

Antenna Connector Type:  Type TNC
Antenna Gain                     2 dBi max.

Processor

Processor Type                  Arm7

Memory

DRAM                               4M Bytes
Flash                                  1M Bytes

Backup Modem

General Caller Identification
V.42 error correction (LAPM and MNP)
V.42bis and MNP class 5 data compression
Connection Rate               56K bits/s
Type Full Duplex or half Duples in Data mode
Half Duplex in fax mode
Interface ITU V.24, RS-232C Serial Interface
The built-in V.90 modem will be triggered to backup the ADSL/Cable connection if the connection fails

Connection

WLAN Interface              1 x IEEE802.11b Access Point
LAN Interface                  1 x RJ45 (embedded 10/100Mbps
base-T Ethernet)
WAN Interface                1 x RJ45 (for broadband connection
to ADSL or Cable Modem)
1 x RS232 (embedded Ethernet)
1 x 56K bps V.90 analog Modem
(for backup the broadband connection, optional)

Power

Power Voltage                 DC 5.1 Volt ± 5%,
AC Adapter AC 100V ~ 240V
Power Consumption         5.1 Volt, 1.0A (Typical)

Product Software Specification

Web-based Configuration

GL2411GW/RT supports management with HTTP protocol World Wide Web.  The system provides a series of web pages written in HTML language, which displays the configuration and status of the system.  The user can view and control the system easily with a standard web brower such as Netscape or Internet Explorer.

Protocol Support

(Wireless) Routing Protocol IP, Static Router, RIP1, RIP2, IAPP, TCPIP
VPN Tunnel Protocol Remote Access, PPTP
Redundancy Virtual Routing Redundancy Protocol (VRRP)
WAN Protocol PPP, PpoE, NAT
Security Support 02.1d /Filter
Server Support DHCP, Server/Client, HTTPD Server, DNS client
User Authentication PAP, CHAP, MSCHAP

Regulation Compliance

Compliant with:
FCC Part 15 Class B, Sec. 15.247 and 15.109 , Part 68
ETS 300 328 and ETS 300 826, EN55022 Class B, EN60950, CE-Mark
MPT RCR STD 33A (Japan, Customerized), TBR16 / 21 (Customerized)

Operating Condition

Compliance to Environmental Test

Anti-Static Voltage

Apply static voltage as follows will not cause any system failure
Static Voltage Bracket 4kV
LED 2kV

Vibration Test

Apply products to the vibration under the frequency and amplitude 10-25 Hz 1mm in vertical direction for one and in horizontal direction for 30 minutes will not cause any products damage.

Package Drop Test

Dropping th package from the height of 100cm for each of the six(6) faces onto the hard-wood floor will not cause any product damage.

Usage Condition

Temper Range

Operating:          -0蚓 ~ 50蚓
                          (Except RF output power and sensitivity)
Storage:             -20°C ~ 70°C

Temperature Shock

The one cycle of temperature shock is staying -30蚓 for 2 hours, taking 1 hour for changing temperature up to +60蚓, and staying at +60蚓 for 2 hours, taking 1 hour for changing temperature to -30蚓. The three cycles of temperature shock will not cause any product damage.

Humidity

Operating:                        0% to 70%
Storage:                           0% to 95% Non-condensing

 

HomeCompanyInformationSite  MapContactDistributorPriceSupportProduct ProductInformationSitemapContactDistributorPriceSupportCompany